clamp for vertical use photo and video shooting Бесплатно 3D Принт Модель

the clamp is suitable for use by small cameras like hero or yi 4k + and other similar ones. you can also use smartphones for shooting.

the clamp can be mounted on the shelf or edge of the table. using the ball head - the viewing angle is not limited. also suitable for other devices for installing cameras.

i used tubes with a diameter of 8 mm, a wall thickness of 1 mm. anodized aluminum. threaded stud - m5 length 110 mm. rubber substrate can be printed with soft filaments.

some parts have to be glued together, but i'm sure you can do it :) in principle, it was possible to make clamps and thinner, but i was reinsured and made a margin of safety. in the video, i showed the stages of assembly of some parts.


for the options of suitable ball heads, see below.

https://goo.gl/5hvxyz
https://goo.gl/v87hje
https://goo.gl/19m1nn
https://goo.gl/dgp4b4
https://goo.gl/zmbhr2

buy & save with cashback




donate with paypal
instagram twitter pinterest tingiverse Для печати: Нет